How to price a 3D print, step by step.

A good price starts from what the print really costs you, then adds what your business needs. These five steps use the same example as the calculators.

Last updated:

1. Start from the full cost per piece

Use the slicer’s grams and time for the whole plate, then add power, machine wear, your hands-on time and extras such as packaging. In the teaching example used across this site (100 g, 2 hours, 15 minutes of work at $20/h, $0.50 of extras) that comes to $7.645 per plate.

If you skip your own time, the same print looks like a $2.65 job. That gap is why many first quotes are too low.

2. Add a reserve for failed prints

Some prints fail and have to be run again. A failure reserve spreads that risk over the prints that succeed. In these tools it applies to material, power and machine wear, not to your labor or extras.

With a 10% failure rate the example adds about $0.24, so the cost becomes about $7.88. Use your own failure rate; 10% is only a teaching value.

Reserve = (material + power + wear) ÷ (1 − failure rate) − (material + power + wear)

3. Choose margin or markup on purpose

Both are called “40%”, yet they produce prices $2.10 apart. Pick the convention your business uses and stay with it, so quotes stay consistent from one customer to the next.

Same $7.88 cost (unrounded $7.8833) with a 10% failure reserve; prices rounded to cents.
MethodFormulaQuote priceProfit share of price
40% markupcost × 1.40$11.0428.59%
40% margincost ÷ 0.60$13.1440.01%

4. Decide on a minimum charge

Small parts can cost more to handle than to print: talking with the customer, slicing, removing supports and packing take time even for a 5 g clip. Many sellers set a minimum order amount so that these fixed minutes are always covered. Choose a minimum from your own time per order, not from someone else’s number.

5. Check the price against your market

A calculated price is a floor, not a promise that customers will pay it. Compare it with what similar work sells for in your area or on the marketplaces where you sell. If your price sits far above, look for costs you can reduce; if it sits far below, you may be undercharging for your time.

Marketplace commissions, payment fees, shipping and taxes change the final amount. Add them separately, because a margin formula does not know about them.

Common pricing mistakes

  • Pricing only by grams of filament and forgetting print hours and finishing work.
  • Leaving out your own time for slicing, support removal and customer messages.
  • Forgetting design or file-repair time when the customer does not send a ready model.
  • Quoting a unit price that does not match the total after rounding. The price calculator rounds the unit price first and multiplies it by the quantity.